Richard Jhon

E-UTRAN configures a priority for all applicable frequencies for each RAT. In addition to the priorities of specific cells that are optionally provided by SI, E-UTRAN can assign specific EU priorities through dedicated signaling. Since frequencies are indicated in the information system, the EU is expected to take into account only the cell reselection which … Read more

Cell selection consists of the UE seeking stronger cell on all supported frequencies of each transport supported rat until it finds a suitable cell. The main requirement for cell selection is that it should not take too much time that becomes more difficult with the growing number of frequencies and rats to be searched. The … Read more

How UE select suitable cell in LTE Here write in simple words how UE select suitable cell in LTE. After the UE has selected a PLMN, is a done selecting cell – in other words, looking for an appropriate cell camp. While camping on the cell, and that is the UE acquires broadcast. Subsequently, the … Read more

Means for transmitting UE In order to avoid signaling of the radio access capability of the UE via an air interface at each transition from RRC_IDLE to RRC_CONNECTED, the core network stores AS capabilities (such as E-UTRA and the possibility GERAN), while the UE is in the RRC_IDLE / EMM-registered. After the connection S1, the … Read more

Depending on the type of measurement, the UE can measure and report any of the following: serving cell; list of cells (e.g., cells shown as part of the object of measurement); cells are found at the frequency set (ie cells are the cells that are not listed, but found UE). For some rats, the UE … Read more

The E-UTRAN can configure the UE to report measurement information to support the control of UE mobility. The following measurement configuration elements can be signaled via the RRC Connection Reconfiguration message. E-UTRAN may configure the UE to report measurement information to support the control elements mobility. Following measurement configuration message can be supplied via the … Read more

Here I write on How Inter-RAT Mobility performs in LTE, means Handover to LTE and Mobility from LTE. Handover to LTE Procedure for handover of LTE is largely the same as the handover procedure in LTE. The main difference is that the handover to LTE AS a whole-configuration must be signaled, and the LTE it … Read more

Here I write some small notes on connection Re-Establishment procedure in LTE. In a number of cases of failure (eg failure of radio link failure of teaching RLC unrecoverable error, failure of compliance reconfiguration), the procedure for restoring EU RRC connection, provided that security is active. If security is not enabled, when one of the … Read more

lets talk about LTE Architecture- SERVICE, EPC, E-UTRAN and User Equipment. In the LTE network is divided into 2 basic networks, namely: 1. EUTRAN (Evolved Universal Terrestrial Radio Access Network) 2. EPC (Evolved Packet Core) SERVICE IP Multimedia Subsystem (IMS) is a good example of cars that can be used in the service layer connectivity Services … Read more