Category: 4G LTE

Any Antenna may be Omni antennas or Directional antenna. Omni antennas provide approximately the same amount of profit throughout the entire 360-degree horizontal pattern. Directional antenna, sometimes referred to as…

Understanding the current subscriber behavior and trends is a valuable guide for a product manufacturer and operator of the capital investment. In this post a few key observations will be…

Throughput or bandwidth that LTE was taken for the physical layer for the MCS under the pick or sustainable conditions. Throughput, individual users might be depends both on the MCS…

An RF propagation model is a mathematical formula used to characterize the radio is Wave transmitter at one end and the other end into the receiver propagation between It is…

Front to back ratio is an important characteristic of directional antenna antenna. Is the ratio of power radiated from a corner with maximum radiation radiation levels at 180 degrees (the…

Side and back lobes are regions in a template where the “directions” the antenna may be of benefit, except for the maximum rate. System engineer Note these characteristics with downtilting…

A couple of differences may exist between the CPE and device specifications  the alleged targets. The differences are mainly due to two factors not normally thought of in the design…

LTE sites deployed by using 3 sector. Each sector operates on the same carrier frequency. Nomenclature for this reuse pattern is 1 x 3 x 1. This range of frequency…

LTE is designed to operate in environments where there are peripheral interventions. Link performance degrades as the C/I (i.e. Carrier interference ratio) is reduced, however, it may be acceptable in…

Management of external interference from all other sites/sectors improves system performance and capacity. Intervention studies are used to examine areas that have significant peripheral interaction problems. Lighting and intervention studies…