Richard Jhon Frequency to Wavelength Formula The Frequency to Wavelength conversion calculator uses the standard relation: λ = c / f Formula Explanation Here, λ (lambda) represents the wavelength in meters, c is the speed of light (approximately 299,792,458 m/s), and f is the frequency in Hertz. By converting the input frequency to Hertz, the formula calculates … Read more
Wavelength to Frequency Formula The Wavelength to Frequency conversion calculator uses the basic wave equation to convert a given wavelength (λ) into its corresponding frequency (f). f = c / λ Formula Explanation Here, f is the frequency in hertz (Hz), c is the speed of light in meters per second (approximately 299,792,458 m/s), and … Read more
Hz to PPM Calculator Formula ppm = (Δf / f₀) × 10⁶ Formula Explanation The Hz to PPM conversion calculator computes how much a frequency deviates relative to its nominal value in parts per million (ppm). Here, Δf is the frequency variation, and f₀ is the nominal center frequency. By dividing the frequency variation by … Read more
Inductive Reactance Calculator Formula XL = 2 × π × F × L BL = 1000 / XL Formula Explanation The Inductive Reactance conversion calculator determines the opposition of an inductor to alternating current. XL represents the inductive reactance in ohms, calculated as 2π times the frequency (F) multiplied by the inductance (L). BL is … Read more
VSWR to Return Loss Formula Return Loss (RL) = -20 × log10((VSWR – 1) / (VSWR + 1)) Formula Explanation This formula converts the Voltage Standing Wave Ratio (VSWR) to Return Loss (RL) in decibels. Return Loss indicates the amount of power reflected back from a load relative to the incident power. A higher RL … Read more
Noise Figure to Noise Factor Formula F = 10^(NF / 10) Formula Explanation This formula converts the Noise Figure (NF) expressed in decibels (dB) into the linear Noise Factor (F). The Noise Factor quantifies how much a device or system degrades the signal-to-noise ratio. By raising 10 to the power of NF divided by 10, … Read more
Noise Factor to Noise Figure Formula NF(dB) = 10 × log₁₀(F) Formula Explanation This Noise Factor conversion calculator converts the linear noise factor (F) of a system into the noise figure (NF) in decibels. The noise factor represents the degradation of the signal-to-noise ratio caused by the components in a system. By applying a logarithmic … Read more
Delta to Wye Conversion Formula The Delta to Wye conversion calculator transforms a three-phase delta network into an equivalent Wye network. The formula calculates each Wye resistance based on the delta resistances Ra, Rb, and Rc. R1 = (Rb × Rc) / (Ra + Rb + Rc) R2 = (Ra × Rc) / (Ra + … Read more
Formula for Wye/Star to Delta Conversion The Wye/Star to Delta conversion calculator uses the following formulas to convert three resistances in a Wye (Star) configuration (R1, R2, R3) into the equivalent Delta resistances (Ra, Rb, Rc): Ra = R1 + R2 + (R1 × R2) / R3 Rb = R2 + R3 + (R2 × … Read more
Microstrip Patch Antenna Formula The Microstrip Patch Antenna conversion calculator estimates the width (W) and length (L) of a rectangular patch antenna based on dielectric properties, substrate height, and resonant frequency. Width (W): W = (c / (2 × f₀)) × √(2 / (εᵣ + 1)) Effective dielectric constant: ε_eff = (εᵣ + 1)/2 + … Read more